tangency

英

美

网络  切线连续; 接触; 相切; 切向参考; 切矢连续

复数：tangencies　

英英释义

noun

• (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
  1. they forget to solder the contacts
  Synonym:contact
• the state of being tangent

双语例句

• Then finally, the final step is to find what is the tangency line that goes through the riskless rate.
  在最后，最终的步骤是找出一条，穿过无风险收益率的切线。
• Aiming at the problem of tangency point reorganization of digital curve, this paper proposes a digital curve tangency point detection technology based on rotate-angle accumulation.
  针对数字曲线的切点识别问题，提出一种基于转角累加的数字曲线切点检测技术。
• Tangency is controlled by the first two control points from a surface boundary, assuming that these points lie in one line.
  相切是由曲面边界的最初两个控制点控制的（假设这些点在一条线上）。
• With the Lagrange multiplier method, the minimum distance of the center of a circle and a quadric surface was provided and the tangency condition of curve and surface was given.
  利用拉格朗日乘子法求解二次曲线和二次曲面之间的最小距离，给出了曲线与曲面相切的条件。
• That would mean that everybody is holding that same portfolio of risky assets and nobody is different, they're only different in how what proportions they hold the risky the tangency portfolio.
  这就意味着每个人，都持有相同风险资产投资组合，每人都是一样的，他们唯一的不同在于-，他们所持有风险资产的比例-，也就是切线资产组合。
• This paper introduces an analyzing technique for determining aspheric particle images and gives a simple way of tangency process between two images.
  从理论上给出了工业中有关类球形微粒的处理和分析方法，并提出了一种简便的图像相切处理方法。
• The tangency portfolio is the portfolio that one should hold.
  切点投资组合就是我们应该持有的投资组合。
• Now, he's using a much longer sample than I did, so he's not going to get this tangency portfolio that I did.
  他的样本跨度比我的要大多了，所以他得出的切线资产组合会和我的不同。
• The optimal allocation of the certainty and severity of penalty under the cost restrain is the point of tangency of the curve of equal deterrence and the curve of equal cost of deterrence.
  成本约束下的刑罚确定性与严厉性的最优配置是等威慑水平曲线与等威慑支出曲线的切点。
• Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
  通过对NURBS曲线的控制顶点扰动，采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征，并讨论了多点几何特征同时修改的情况。