词语吧>英语词典>slenderness翻译和用法

slenderness

英 [ˈslɛndənəs]

美 [ˈslɛndərnəs]

网络  细长度; 长细比; 纤细; 名词; 细长

BNC.40473 / COCA.40756

英英释义

noun

  • the property of an attractively thin person
      Synonym:slightnessslimness
    1. relatively small dimension through an object as opposed to its length or width
      1. the tenuity of a hair
      2. the thinness of a rope
      Synonym:thinnesstenuity
    2. the quality of being slight or inadequate
      1. he knew the slenderness of my wallet
      2. the slenderness of the chances that anything would be done
      3. the slenderness of the evidence

    双语例句

    • The displacement ductility of the CFSSTC specimens were analyzed, the effects of the steel ratio, the slenderness ratio, and the axial compression ratio on the ductility of the CFSSTCs were studied.
      同时研究了含钢率、长细比和轴压比对方钢管混凝土柱延性的影响。
    • According to the slenderness ratio and the maximum windward area, four experiments are designed.
      按不同的长细比和不同的最大迎风面积设计了四个实验。
    • Bearing behavior of cast-in-place piles with similar slenderness ratios in deep soil layer
      深厚土层中长径比相近灌注桩承载性状
    • Volumetric efficiency, slenderness, span over length ratio increase with the cone angle.
      体积率、细长比和展长比都随着基本流场圆锥角的增大而增大。
    • Study on Wind-induced Vibration Characteristics of Two Classes of Bridge Components with Large Slenderness Ratio
      两类大长细比桥梁构件的风振特性研究
    • On the Nose Profile Role and Slenderness Ratio of Projectile in Penetration Numerical simulation of penetration process for PELE projectile against target
      弹丸头部形状和长径比对侵彻过程的影响研究PELE弹侵彻过程壳体膨胀破裂的数值模拟
    • According to the relationship between the structural strength and slenderness of plate elements, the limited width-to-thickness ratio of the flange of a box-section column under seismic load is derived.
      由构件承载力与壁板宽厚比的关系,得出了抗震设计箱形截面柱翼缘板宽厚比限值。
    • Based on model experiment and simulated experiment, the formula of equivalent slenderness ratio was established.
      在模型试验和仿真试验的基础上,提出了单边连接高强角钢等效长细比公式。
    • A calculation method for equivalent slenderness ratio by a graphical method is presented.
      给出了应用图表法的换算长细比计算方法。
    • Bounds slenderness ratio among axial compression short columns, middle long columns and long columns were determined.
      确定了钢管煤矸石混凝土轴心受压短柱与中长柱以及中长柱与长柱的界限长细比;