bluing
英
美
n. 烤蓝; 蓝色漂白剂；上蓝剂; 蓝化；烧蓝；模温过高而引起的绿色氧化膜
COCA.46990
英英释义
noun
- a process that makes something blue (or bluish)
- used to whiten laundry or hair or give it a bluish tinge
双语例句
- Tapered bores for keyed hubs shall have a minimum of70% transfer of bluing ( surface contact) to the taper gage.
键槽轮毂的锥孔应至少有70%的着色（表面接触）转移到锥度计上？ - The practice shows that proper measures can be taken to effectively prevent red exo-frost on bluing coating.
实践证明，采用适当措施可以有效防止发蓝膜的红色挂霜。 - A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hytrogen furnace was introduced.
介绍了无涂层电工钢冲片叠片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。 - Illustrated in detail the whole process and cautions of basic bluing treatment from solution preparation, oxidization to operation procedure.
本文从溶液配制、氧化规范到操作程序，详细介绍了碱性发兰处理的全过程及其注意事项。 - The production shows that the best bluing time in normal temperature is from 4 to 8 minutes and bluing film is bright and anti-corrosion capacity is at or higher than the specified state standard.
生产实践表明，常温发蓝的最佳发蓝时间为4~8分钟，发蓝膜光亮，耐蚀达到并超过国家规定标准。 - The paper introduces a new technology of bluing in normal temperature with characteristics of high efficiency, energy-saving and non-pollution.
阐述了具有高效、节电、无污染等特点的常温发蓝新工艺。 - Study of Basic Bluing Processing
关于碱性发兰工艺的分析 - The mechanism and treatment process as well as applying effect of bluing in alkaline media and blackening at room temperature for surface treatment of steel parts were contrasted, the optimal conditions and application using two surface treatment methods in the production were obtained.
本文作者旨在通过两种表面处理方法的形成机理、工艺流程以及运用效果的对比，得出两种方法在生产上的应用范围和适宜条件。 - Adhesion, wear and corrosion resistance of the coatings obtained were compared with those of conventional bluing at room temperature.
测量了发蓝膜的附着力、耐磨和耐蚀性，并与传统常温发蓝进行了对比。 - In view of the weaknesses of conventional bluing at room temperature such as poor adhesion and wear resistance, a composite bluing process for spring parts at room temperature was advanced.
传统的常温发蓝工艺存在着附着力和耐磨性差的缺点。研究了一种用于弹簧件的常温复合发蓝工艺。